How To Take care of your pool cue!!!

Cue Care
• Don’t lean your cue against a wall or any other surface. As this may bend the end of your cue.
• Don’t leave your cue next to a heat source like a radiator or in a hot car. As this may warp your cue.
• Be careful not to bang the cue butt on hard floors. Although Elegance cues have a protective leather covering on the bottom of the cue, banging the end of the cue on a hard floor can cause the wood splices to split.
• Try to store your cue flat, in a cue rack or ideally in a hard case. As this will help to prevent your cue warping or getting bent.
• Transport your cue in a case where possible to avoid knocks.
• Bed your new cue’s tip in (see bedding in your cue tip below).
Your Cue Tip
• All our cues come with stick on tips. Cheaper cues use screw on or push on tips but professionals always use stick on tips.
• These tips are designed to be easily removed and changed either when they are worn down or when a player wishes to change the tip for one he or she prefers (i.e. a harder or softer tip or a different make).
• The tips can be removed by using a sharp blade like a stanley knife and sliding it between the tip and the cue (this should only be done by an adult and extreme care should be taken).
• As these tips are designed to be easily removed, occasionally with a new cue and the vibrations of transportation during delivery the tip may fall off (as detailed in the BBC link below).
Re-Tipping Your Cue
• Essentially make sure the tip and cue surfaces are clean, maybe using a piece of sand paper.
• Use superglue (ideally gel based as water based superglue can be too brittle) or a cue tip cement to attach your tip.
• Then place the tip on the cue and press down firmly with your finger. Leave the cue for as long as possible to form a good bond, ideally overnight at least.
Bedding in Your New Cue or Cue Tip
• Every new cue obviously has a new tip and it is important to bed it in as you would if you had replaced the tip.
• This involves playing only gentle shots with your cue when first used, ideally as many gentle shots as possible.
Is My Cue Cracked?
• My Cue Makes a Funny Sound When I Play a Shot, a Twang Like it’s Cracked.
• Don’t worry if you had split your cue it would be very obvious.
• The common cause of this effect is a loose tip and is simply cured by removing and re-gluing your tip.
• When you remove your tip it may be worth checking the brass ferrule. Not to forcefully, try to pull the ferrule off or see if it moves slightly, if so add a bit of tip cement or gel based superglue and replace. Re-tip the cue and then leave over night (at least) and you’ll be left with a cue with a lovely feel.
Minor Scratches on Ash Shaft
• If you manage to get small scratches on the Ash shaft of your cue you should be able to remove these scratches using wire wool and then polishing wish clear bee’s wax.
• You can maintain your cue by polishing it with clear bee’s wax every five years or as needed. Wax a small area first to see that you are happy with the feel on your hand first.

Article Directory: http://www.articledashboard.com

www.gamerooms.ca